Publicidad
Idiomas disponibles
Idiomas disponibles
2. Push in the button on the top of the pin and pull the
pin out.
3. Put the pin in the hole for the correct cutting height.
4. Push the transport latch lever forward to lower the
cutting deck into mow position.
To start the engine
1. Push the PTO button to disengage the drive on the
cutting deck.
2. Move the throttle lever to ½ throttle position.
3. Engage the parking brake. Refer to
disengage the parking brake on page 12 .
4. If the engine is cold, pull up the choke control fully.
2374 - 001 - 26.02.2024
5. Push in and turn the ignition key to the start position.
6. When the engine starts, immediately release the
7. Slowly push in the choke control if the choke was
8. Let the engine run at ½ throttle for 3-5 minutes
9. Push the throttle control to the full throttle position.
To operate the product
1. Start the engine. Refer to
To engage and
2. Push down the 2 control levers to engage the OPC.
3. Disengage the parking brake. Refer to
Note:
Do not keep the ignition key in the start
position for more than 5 seconds at a time. If the
engine does not start, wait 15 seconds before you try
again.
ignition key to the run position.
used.
before you apply heavy load.
page 13 .
and disengage the parking brake on page 12 .
To start the engine on
To engage
13
Publicidad
