Publicidad
Idiomas disponibles
Idiomas disponibles
5. Put the oil drain hose through the hole in the frame.
6. Put a container below the oil drain hose.
7. Remove the oil drain plug.
8. Let the oil run out into the container.
9. Install the oil drain plug.
10. Fill with new oil as given in
31 .
11. Put the oil drain hose into initial position.
12. Do a check of the engine oil level. Refer to
check of the engine oil level on page 23 .
13. Fill with oil to the FULL mark on the oil dipstick.
Note:
For safe disposal of used engine oil, refer to
Disposal on page 30 .
Lubrication, general information
•
Remove the ignition key to prevent accidental
movements during lubrication.
•
Clean the area before you lubricate a part on the
product.
•
Use oil when you lubricate with an oil can.
•
When you lubricate with grease, use a chassis or
ball bearing grease that prevents corrosion. Remove
unwanted grease after lubrication.
•
Lubricate 2 times a week if you operate the product
daily.
•
Do not spill lubricant on the drive belts or the
grooves of the belt pulleys. If you do spill, clean with
alcohol. If the friction between the drive belt and the
pulley is not sufficient after you clean with alcohol,
replace the drive belt.
CAUTION:
petroleum products to clean drive belts.
To do a check of the transmission oil
level
Note:
Do the transmission oil check when the
transmission is cool.
24
Technical data on page
To do a
Do not use gasoline or other
1. Put the product on a horizontal surface.
2. Loosen the knob and tilt the pump cover for the
hydraulic tank.
3. Turn the oil cap (A) counterclockwise and remove it.
A
4. Do a check of the hydraulic oil level. The hydraulic
oil level must be between the 2 holes (B) inside the
oil tank (B).
5. Fill the hydraulic tank with hydraulic oil if necessary.
Use correct transmission oil type, refer to
data on page 31 .
6. Install the oil cap.
7. Install the pump cover for the hydraulic tank. Tighten
the knob fully.
B
Technical
2374 - 001 - 26.02.2024
Publicidad
