Cameo EVOS W7 IP Manual De Usuario página 12

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS
5
1 POWER IN
IP65 power input socket with rubber sealing cap. Operating voltage 100–240 V AC/50–60 Hz.
Connection via supplied power cable (when not in use, always close with the rubber sealing cap).
2 POWER OUT
IP65 power output socket with rubber sealing cap. Enables power supply to other CAMEO
spotlights. Ensure that the total current consumption of all connected devices does not exceed
the value specified on the device in amperes (A) (when not in use, always close with the rubber
sealing cap).
3
DMX IN
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console; when not in
use, always close with the rubber sealing cap).
4
DMX OUT
Female IP65 5-pin XLR socket for forwarding the DMX control signal (when not in use, always
close with the rubber sealing cap).
5
NET IN / OUT
RJ45 network connections for connecting to an ArtNet, sACN or Kling-Net network (NET IN) and
for forwarding the control signal (NET OUT). Always close with the rubber sealing cap when not in
use. Use cables with IP65 rating and CAT 5e or better cables to set up the network.
6
W-DMX ANTENNA
™
Antenna for W-DMX
12
3
6
control.
™
4 1
7
2