Cameo EVOS W7 IP Manual De Usuario página 16

Note on the main screen in operating modes with external control: When the control signal is
interrupted, the characters in the display start flashing; when the control signal is present again,
the flashing stops.
Warning message: If the warning symbol (triangle with exclamation mark) appears in the display,
there is an error in one or more components of the unit. The affected components can be viewed
in the Info Menu under Error Info. If the error cannot be rectified by a restart or reset, please
contact an authorised service centre.
W-DMX
™
To pair a W-DMX receiver with a W-DMX compatible transmitter, the Reset command must be
executed in the receiver menu under Connect (select Reset and confirm). The receiver is now in
pairing standby and waiting for a pairing request from a transmitter. Start the pairing process by
selecting Link in the menu of the transmitter and confirm; the devices are now paired automati-
cally. In the same way, several receivers can be paired simultaneously or one after the other to
a transmitter (e.g. for master/slave operation). A W-DMX connection is always maintained until it
is disconnected by means of the Reset command in the receiver or the Unlink command in the
transmitter, regardless of whether a device has been disconnected from the power supply in the
meantime.
W-DMX STATUS
™
W-DMX
™
deactivated
W-DMX
™
activated as
transmitter with
G3 standard,
DMX signal
available
16
W-DMX
™
activated as
receiver, not as receiver
paired and paired,
transmitter is
switched off or
out of range
W-DMX
™
activated as
activated as
transmitter with
transmitter with
G3 standard, no
G4s standard,
DMX signal
DMX signal
available
W-DMX W-DMX
™
activated activated as
receiver and
paired, no DMX
signal
W-DMX W-DMX
™
with G4s standard, no DMX signal
W-DMX
™ ™
activated as
receiver and
paired, DMX
signal available
activated as transmitter
™