Cameo EVOS W7 IP Manual De Usuario página 9

3. The exterior surface of the device can become very hot during regular operation.
Ensure that accidental touching of the housing is not possible. Always allow the
lamp to cool sufficiently before removal, maintenance work and charging etc.
ATTENTION:
1. Do not install and operate the device in the vicinity of radiators, heat accumulators,
ovens, or other heat sources. Ensure that the device is always installed in such a
way that it is sufficiently cooled and cannot overheat.
2. Do not place ignition sources such as burning candles near the device.
3. Vents must not be covered and fans must not be blocked.
4. Use the original packaging or packaging provided by the manufacturer for transport.
5. Avoid shock or impact to the device.
6. Observe the IP rating as well as the ambient conditions such as temperature and
humidity according to the specification.
7. Devices can always be further improved. In the event of any discrepancies between
the operating instructions and the device labelling with regard to operating condi-
tions, performance or other device characteristics, the information on the device
always takes precedence.
8. The unit is not suitable for tropical climates and for operation at elevations higher
than 2000 m above sea level.
9. Unless explicitly stated, the unit is not suitable for operation in marine conditions.
CAUTION! IMPORTANT INFORMATION REGARDING LIGHTING PRODUCTS!
1. Never look directly into the beam of light, not even for a short period of time.
2. Never look into the beam of light using optical devices such as a magnifying glass.
3. Stroboscopic effects may cause epileptic seizures in susceptible individuals!
SIGNAL TRANSMISSION BY RADIO (E.G. W-DMX OR WIRELESS AUDIO SYSTEMS):
The quality and performance of wireless signal transmissions generally depends on
the ambient conditions.
For example, the following factors can impact range and signal stability:
Shielding (e.g. masonry, metal structures, water)
High volumes of radio traffic (e.g. powerful wireless LAN networks)
Interference
Electromagnetic radiation (e.g. LED video screens, dimmers)
All range specifications refer to free-field line-of-sight applications without interference!
The operation of transmission systems is subject to official regulations. These may
vary from region to region and must be checked by the operator before use (e.g. radio
frequency and transmission power).
9