Sauder 1736-100 Instrucciones De Montaje página 12

8
END
MOLDING (X)
- Position the LEFT END (B) next to the RIGHT END (A) as shown.
- Slide a patented* END MOLDING (X) onto the notch of the LEFT END (B). Carefully slide the MOLDING until
the MOLDING is even with the top edge of the LEFT END.
NOTE: The END MOLDING is shorter than the LONG END MOLDING (Y).
NOTE: The END MOLDING should overhang the surface with the RAIL on the LEFT END. If the
MOLDING overhangs the wrong surface, remove it and slide it on again. Slide the MOLDING
off the notch in the same direction that it was slid on.
- Slide a patented* LONG END MOLDING (Y) onto the notch of the RIGHT END (A). Carefully slide the
MOLDING until the MOLDING is even with both edges of the RIGHT END.
NOTE: The MOLDING should overhang the surface with the rail on the RIGHT END. If the MOLDING
overhangs the wrong surface, remove it and slide it on again. Slide the MOLDING off the
notch in the same direction that it was slid on.
* U.S. Pat. No. 5,499,886
1736--100
Slide the END
MOLDING (X)
onto the notch.
LEFT
END (B)
Surface with
TWIST-LOCK R
FASTENERS
www.sauder.com/services
Slide the MOLDING until
it is even with the top
edge of the LEFT END.
RIGHT
END (A)
Surface with
TWIST-LOCK R
FASTENERS
LONG END
MOLDING (Y)
Slide the
LONG END
MOLDING (Y)
onto the notch.