Sauder 1736-100 Instrucciones De Montaje página 37

17
HINGE (SS)
9/16" LARGE HEAD SCREW (FFF)
(4 used for the HINGES)
- Fasten two HINGES (SS) to the DOOR (Q) as shown. Use two 9/16" LARGE HEAD SCREWS (FFF) through each
HINGE and into the pre- -drilled holes in the DOOR.
NOTE: Be sure to position the HINGES as shown. Follow the enlarged diagram.
- Fasten a STRIKE PLATE (LL) to the DOOR (Q) as shown. Use a 1/2" FLAT HEAD SCREW (GGG) through the
STRIKE PLATE and into the pre- -drilled hole in the DOOR.
NOTE: The surface with "SAUDER" on the STRIKE PLATE should be facing up. Be sure to position the
STRIKE PLATE as shown. Follow the enlarged diagram.
DOOR (Q)
www.sauder.com/services
STRIKE
PLATE (LL)
1/2" FLAT HEAD SCREW (GGG)
(1 used for the STRIKE PLATE)
1736--100