Publicidad
Idiomas disponibles
Idiomas disponibles
10
Finished
edge
BASE (AA)
Unfinished
edge
END
MOLDING (X)
BOTTOM (M)
- Fasten the UPRIGHT (I) to the DESK TOP (E) and BOTTOM (M) as shown. Tighten the TWIST-LOCK
FASTENERS in the UPRIGHT and BOTTOM.
NOTE:
Be sure the finished edge of the UPRIGHT is facing up.
- Now, fasten the MAGNETIC CATCH (MM) to the UPRIGHT (I) as shown. Use a 1- -1/8" PAN HEAD
SCREW (AAA) through the MAGNETIC CATCH and into the pre- -drilled hole in the UPRIGHT. Follow the enlarged
diagram closely.
- Fasten two ANGLE BRACKETS (QQ) to the BOTTOM (M) as shown. Fasten an ANGLE BRACKET (QQ) to
the LEFT END (B) and UPRIGHT (I). Fasten three ANGLE BRACKET (QQ) to the DESK TOP (E) as shown.
Use a 9/16" LARGE HEAD SCREW (FFF) through each ANGLE BRACKET and into the pre- -drilled holes in the
BOTTOM and DESK TOP.
NOTE:
Be sure to position the ANGLE BRACKETS as shown. Follow the diagram closely.
- Now, fasten the BASE (AA) and the DESK TOP MOLDING (W) to the ANGLE BRACKETS on the BOTTOM
and DESK TOP as shown. Use a 9/16" LARGE HEAD SCREW (FFF) through each ANGLE BRACKET and into
the pre- -drilled holes in the BASE and into the groove in the DESK TOP MOLDING.
NOTE:
Be sure the unfinished edge of the BASE is facing as shown. Be sure the DESK TOP
MOLDING is against the END MOLDING. The SCREWS will tighten into the groove in the
DESK TOP MOLDING. Do not overtighten the SCREWS.
1736--100
Be sure the
DESK TOP
MOLDING (W) is
against the END
MOLDING (X).
DESK TOP
MOLDING (W)
LEFT
END (B)
UPRIGHT (I)
ANGLE
BRACKET (QQ)
www.sauder.com/services
1- -1/8" PAN HEAD SCREW (AAA)
(1 used in this step)
MAGNETIC
CATCH (MM)
DESK
TOP (E)
9/16" LARGE HEAD SCREW (FFF)
(14 used in this step)
R
Publicidad
