Publicidad
Idiomas disponibles
Idiomas disponibles
13
STOP
Do NOT stand the unit
upright without the
BACKS fastened. The
unit may collapse.
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
- Unfold the UPPER BACK (G) and lay it over the upper portion of your unit with the unfinished surface facing up.
NOTE:
Be sure the notch in the UPPER BACK is positioned toward the DESK TOP (E). Follow
the diagram.
NAILING ON THE UPPER BACK:
1st:
Tap a NAIL (III) into the row of holes along the top edge of the UPPER BACK (G).
2nd: Be sure there is an equal amount of margin along all four edges of the UPPER BACK. This will assure your
unit is "square."
3rd: Then, tap a NAIL into the row of holes along the bottom edge of the UPPER BACK.
- Continue fastening the UPPER BACK (G) to your unit using the NAILS (III).
NOTE:
Be sure to tap NAILS into the holes that line up over the SMALL SHELF (N) and HUTCH
UPRIGHT (J). Follow the diagram.
- Now, lay the LOWER BACK (H) over the lower portion of your unit with the unfinished surface facing up.
NOTE:
Be sure the notch in the LOWER BACK (H) fits into the notch in the UPPER BACK (G).
NAILING ON THE LOWER BACK:
1st:
Tap a NAIL (III) into the row of holes along the top edge of the LOWER BACK (H).
2nd: Be sure there is an equal amount of margin along the other three edges of the LOWER BACK.
3rd: Then, tap a NAIL into the row of holes along the bottom edge of the LOWER BACK.
- Continue fastening the LOWER BACK (H) to your unit using the NAILS (III).
NOTE:
Perforated cut- -out lines have been provided for access through the BACKS. Carefully cut out
the size of hole needed.
STOP
www.sauder.com/services
These holes should line
up over the SMALL
SHELF (N) and
HUTCH UPRIGHT (J).
UPPER
BACK (G)
Unfinished
surface
LOWER
BACK (H)
Unfinished
surface
LEFT
END (B)
Notch
NAIL (III)
(45 used in this step)
1736--100
Publicidad
