Sauder 1736-100 Instrucciones De Montaje página 7

3
For assembly tips involving
this step, visit our web site
at: www.sauder.com/tips
Notch
Finished
edge
HUTCH
UPRIGHT (J)
Follow the diagrams closely for this step. Be sure the parts are positioned as shown.
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully inserted in the
hole of the adjoining part while locking the FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as tight as possible.
- Position the HUTCH TOP (F) on edge as shown.
NOTE: Be sure the HUTCH TOP MOLDING (V) is up off the floor.
- Fasten the HUTCH RIGHT END (C) and HUTCH LEFT END (D) to the HUTCH TOP (F). Tighten the
R
TWIST-LOCK FASTENERS in the HUTCH ENDS.
NOTE: Be sure the notches on the HUTCH ENDS are facing up.
- Fasten the HUTCH UPRIGHT (J) to the HUTCH TOP (F). Tighten the TWIST-LOCK
HUTCH UPRIGHT.
NOTE: Be sure the finished edge of the HUTCH UPRIGHT is facing up.
HUTCH
LEFT
END (D)
R
www.sauder.com/services
Tighten the FASTENER as tight
as possible after inserting the
dowel end of the FASTENER into
the hole of the adjoining part.
HUTCH
TOP (F)
Notch
HUTCH
RIGHT
END (C)
FASTENER (Refer to the enlarged diagram.)
HUTCH TOP
MOLDING (V)
R
FASTENERS in the
1736--100