Sauder 1736-100 Instrucciones De Montaje página 34

14
DRAWER
BOX
FRONT (S2)
- Fasten two DRAWER SIDES (T2) to one of the DRAWER BOX FRONTS (S2). Use two 1- -1/4" FLAT HEAD
SCREWS (YY) through the holes in each DRAWER SIDE and into the holes in the edges of the DRAWER
BOX FRONT.
NOTE: Be sure the grooves in each part line up with each other on the inside of the drawer.
- Slide a DRAWER BOTTOM (U2) into the grooves in the DRAWER SIDES and DRAWER BOX FRONT.
NOTE: Be sure the finished surface of the DRAWER BOTTOM is facing up.
- Fasten another DRAWER BOX FRONT (S2) to the DRAWER SIDES (T2). Use four 1- -1/4" FLAT HEAD
SCREWS (YY) through the holes in the DRAWER SIDES and into the holes in the edges of the DRAWER
BOX FRONT.
NOTE: Be sure the DRAWER BOTTOM fits into the groove in the DRAWER BOX FRONT.
1736--100
DRAWER
SIDE (T2)
DRAWER
BOTTOM (U2)
Finished
surface
www.sauder.com/services
DRAWER
BOX
FRONT (S2)
DRAWER
SIDE (T2)
1- -1/4" FLAT HEAD SCREW (YY)
(8 used in this step)