Sauder 1736-100 Instrucciones De Montaje página 29

9
Be sure the
small holes are
located here.
LEFT
END (B)
Unfinished
surface
BOTTOM (M)
- Fasten the LEFT END (B) to the DESK TOP (E) as shown. Tighten the TWIST-LOCK
LEFT END.
NOTE: Be sure the END MOLDING (X) on the LEFT END is up off the floor.
- Fasten the BOTTOM (M) to the LEFT END (B). Tighten the TWIST-LOCK
NOTE: Be sure the unfinished surface of the BOTTOM is facing as shown. Be sure the small holes
in the BOTTOM are in the location shown. Follow the diagram closely.
END
MOLDING (X)
www.sauder.com/services
DESK
TOP (E)
R
FASTENERS in the BOTTOM.
R
FASTENERS in the
1736--100