Publicidad
Idiomas disponibles
Idiomas disponibles
EN
4. Before connecting the device to the power source, make sure that the speed control knob (2) is
in the "0" position.
ASSEMBLY OF ACCESSORIES
STEP 1 - BOWL ASSEMBLY
1. Release the tillable head (1) by pressing the head lock lever (6), then gently lift the tilting head until
a click (the sound of the lock triggering) can be heard.
2. Place the bowl (4;5) in the base (7), then turn it (4;5) clockwise so that the protrusions on the bowl
engage with the latches on the base (7).
STEP 2 - MOUNTING THE BOWL COVER
1. Slide the cover (8) over the edge of the housing covering the drive shaft with the pin (3). Then, turn
the cover (8) clockwise (the direction marked with the closed padlock symbol). Please note if the
opening for adding ingredients is facing outwards so that the tillable head (1) does not hinder ac-
cess to the opening.
STEP 3 - ATTACHING THE STIRRERS
1. Push (until a resistance can be felt) one of the three dedicat-
ed stirrers (9, 10, 11) onto the drive shaft pin (3). Make sure
that the spline on the pin fits into the mounting hole of the
stirrer. Then turn the stirrer counterclockwise until the tab
locks against the edge of the stirrer mounting hole.
WORKING WITH THE DEVICE
After attaching the stirrers (9, 10, 11), the device is
ready for operation. Press the head lock button (6) and
gently lower the tillable head (1) until you a click can be
heard (the sound of the lock triggering). Make sure the tillable head is properly locked.
Then place the food in the bowl (4;5) through the hole in the bowl cover (8), connect the
device to the power supply and set the desired speed with the speed control knob (2).
CAUTION! In the case of the PULSE function, the speed control knob (2) must be held down.
After releasing the knob (2), it automatically returns from the PULSE position to the "0" position,
which turns the device off.
CAUTION! Do not press the head lock button (6) during the operation of the robot!
After work is finished, set the speed control knob (2) to the "0" position and disconnect
the device from the power source.
REMOVING ACCESSORIES
The accessories can be dismantled after the tillable head (1) has been inseminated.
The accessories are released from the latches when turned counterclockwise. Before
turning, the stirrers (9, 10, 11) must first be released from the lock, i.e. pushed deeper
onto the drive shaft pin until resistance is felt. After dismantling the mixers (9, 10, 11) is
finished, the bowl cover (8) should be removed.
26
Mounting
hole
Publicidad
