Olimpia splendid Alysea E Instrucciones Para El Uso Y El Mantenimiento página 75

REMOTE CONTROL
SELF‐CLEAN function
To active this function, turn off the indoor unit
at first, then press
HEALTH
then you will hear a beep,
appear on the indoor LED, and
appear on the remote display .
1. This function helps carry away the accumulated
dirt, bacteria, etc from the indoor evaporator.
2. This function will run about 30 minutes, and it
will return to the pre‐setting mode. You can
press button to cancel this function during
the process.
You will hear 2 beeps when it's finished or
cancelled.
It's normal if there is some noise during this
function process, as plastic materials expand
with heat and contract with cold.
We suggest operating this function at the
following ambient conditions to avoid the
activation of the safety devices.
Indoor unit Temp < 86
Outdoor unit
41 o F (5
It's suggested to utilize this function every
3 months.
8 C heating function
o
1. Long press ECO button over 3 seconds to active
o
this function, and 8 C ( 46 F
the remote display.
Do it again to deactivate
2. This function will auto start the heating mode
when the room temperature is lower than 8
(46 o F), and it will return to standby if the
temperature reaches 9
3. If the room temperature is higher than 18
(64 F), the appliance will cancel this function
o
automatically.
button
AC will
will
F (30 C)
o o
o C) < Temp < 86 o F (30 o C)
o
) will appear on
this function.
o C
o C (48 o F).
o C
Gentle Wind function
1. Turn on the indoor unit, and change to COOL
mode, then press
to active this function,
the display.
Do it again to deactivate it.
2. This function will auto close the vertical flaps,
and give you the comfortable gentle wind feeling.
Fresh Air function
This function will pump the fresh air
FRESH AIR
from outside to inside
FRESH
Press the button
Then, select the desired fan speed.
The following will appear on the display:
Auto fan speed
High fan speed
OFF (no indicator)
Note:
This function is available when in OFF/Heating
1.
Cooling/Fan/Auto mode.
In OFF mode, the air conditioner may run
2.
automatically because of the big difference of
temperature between indoor and outside.
3. If the display shows the Fresh Air
indicator and shows CL. It is necessary to
replace the filter and long press button
over 5 seconds to reset the alarm.
12
EN - 21
GENTLE WIND
button or
will appear on
to activate this function.
AIR
Low fan speed
(Flash)
Mid fan speed
FRESH
AIR