Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Materials
1
Accessories
List of accessories
Installation & Owner's
Manual X 1
IDU Installation
Instructions
(Make sure to hand it
over to the user)
Wall hole sleeve X 1
Screw ST3.9*6.5 X 4
[ Note ]
Check the accessory kit for the above items and contact your local dealer for any missing items.
Do not throw away any accessories that may be required for installation until the installation is complete.
Wired/remote controller is optional and needs to be purchased separately.
2
Locally Purchased Accessories
[ Caution ]
Materials, including copper pipes, drainage hoses, various fasteners (such as pipe supports, clamps, and screws),
power cables, and signal cables to be used for field installation need to be purchased on site by the installation operator.
Materials and specifications must comply with relevant national or industry standards.
Brass nut X 2
Drainage hose X 1
For use in the
installation of
connecting pipe
Wall hole sleeve cover
Binding tie X 1
X 1
Capacity
kW≤5.6
5.6＜kW≤9.0
Remarks
Drainage hose
This is used to extend the
IDU's drainage pipe, 16mm in
external diameter. The length
is determined according to
actual needs.
Installation board X 1
Power cable clamp
X 2
Connecting piping (unit: mm)
Piping
Liquid side
Φ6.35×0.75
Φ9.52×0.75
For connection of the IDU refrigerant system, it is
recommended to use a soft copper tube (T2M), with the length
selected according to the actual situation.
25
Installation
Rubber sleeve of
expansion screw X 4
Screw ST3.9*25 X 4
Gas side
Φ12.7×0.75
Φ15.9×1.0
Thermal insulation pipe
The thickness of the insulation pipe
for the copper pipe is usually
15mm or above; and the thickness
of the insulation pipe for the UPVC
plastic tube is usually 10mm or
above. If the pipe is used in a
closed humid area, the thickness
should be increased.
Publicidad
