Publicidad
EN
Figure 3
STEP 1 (Fig.3)
Atach the opener head to the steel track. Assembly the 2 "U" Hanging brackets with 6mm nuts supplied.
STEP 2 (Fig.3)
Place the steel track and opener head assembly centrally on the garage floor, with the open head furthest away from
the door. Li� the front of the track up to the door bracket. Insert the pivot pin and secure it with the split pin
supplied.
STEP 3 (Fig.3, Fig.4)
Li� and support the opener head (with a ladder) so it is posi�oned centrally and level. Fix the opener and track on
ceiling by Iron bracket A & B.
WARNING: Do not allow children around the door, opener or suppor�ng ladder serious injury and/or damage may
result from failure to follow this warning.
STEP 4 (Fig.3, Fig.5)
Connect the straight arm to the bent arm with the bolt. Posi�on and bolt the arms to the top edge of the door using
the bolt supplied.
STEP 5
Li� the garage door un�l the shutle locks into the drive chain/belt.
Now, ready to program the openers.
Figure 4
Publicidad
