Publicidad
EN
7. REVERSAL HEIGHT SETTING
a) Press and hold SET Buton un�l "1" appears
on the display, next press the UP buton un�l
"7" appears on the display to enter this
func�on se�ng then release the buton.
b) Press the SET buton again. The unit is now
in reversal height adjustment mode. And then
you will see a figure "0" with flash dot appears
on the display.
c) Press UP / Down buton once to set the
reversal height while closing (0~9).
d) Press UP buton to increase, or DOWN
buton to decrease.
Figure "0" means the door will rebound to
the open limit posi�on. Figure 1~9 means the
door will rebound to the posi�on of the
whole travel. One tenth to Nine tenth of the
whole travel etc...
e) Press SET buton to confirm the set and it
will back to standby status automa�cally and
display "ll".
NOTE: The reversal height is set on "0"as
standard in factory.
1 – Increase height
2 – Decrease height
Publicidad
