Publicidad
EN
6. LED OFF DELAY TIME SETTING
a) Press and hold SET Buton un�l "1" appears
on the display, next press the UP buton un�l
"6" appears on the display to enter this
func�on se�ng then release the buton.
b) Press the SET buton again. The unit is now
in LED off delay �me adjustment mode. And
then you will see a figure "3" with flash dot
appears on the display.
c) Press UP / Down buton once to set the LED
off delay �me (1~9).
d) Press UP buton to increase the �me, or
DOWN buton to decrease the �me.
The delay �me is 1 minute*N, N=1~9. The
maximum delay �me is 9 minutes.
e) Press SET buton to confirm the set and it
will back to standby status automa�cally and
display "ll".
NOTE: The LED off delay time is set on "3" as
standard in factory.
1 – Increase time
2 – Decrease time
Publicidad
