Publicidad
EN
4. AUTOMATIC CLOSING&TIME SETTING
NOTE: We recommend that Safety Photo Beams
be used in any installa�on where the Auto Close
func�on is enabled.
a) Press and hold SET Buton un�l "1" appears on
the display, next press the UP buton un�l "4"
appears on the display to enter this func�on
se�ng then release the buton.
b) Press the SET buton again, the unit is now in
automa�c close adjustment mode. And then you
will see a figure "0" with flash dot appears on the
display.
c) Press UP / Down buton once to set the auto
close �me (0~9).
Press UP buton to increase the �me, or DOWN
buton to decrease the �me.
The close �me is 15second*N, N=0~9. The
maximum �me is 135s. To disable Auto Close
Func�on, set �me to zero (0).
d) Press SET buton to confirm the set and it will
back to standby
status automa�cally and display "ll".
NOTE:
1. The closing �me is set on "0"as standard in
factory.
2. If the Photo Cell Function is on, and it's broke
by the obstruction, the auto close time will stop
for a while, and then continue the automatic close
time again.
1 – Increase time
2 – Decrease time
Publicidad
