Publicidad
EN
L. OPENING LIFTING FORCE ADJUSTMENT
CAUTION: The opening li�ing force adjustment is set
automa�cally during programming. Normally no
adjustment is necessary.
a) Press and hold SET Buton un�l "1" appears on
the display, next short press the UP Buton un�l "L"
appears on the display to enter this func�on se�ng
then release the buton.
b) Press the SET buton again, the unit is now in
opening li�ing force adjustment mode. And then you
will see a figure "5" with flash dot appears on the
display.
c) Press the UP buton to increase the pull se�ng or
the DOWN buton to decrease the pull se�ng.
The minimum li�ing force is "1"and it can be
adjusted upward. The maximum li�ing force is "9".
d) Press SET buton to confirm the set and it will
back to standby status automa�cally and display "
".
NOTE: The li�ing force is set on "5" as standard in
factory.
:
Note
The model used for this function is
determined according to the actual program.
Publicidad
