Descargar Imprimir esta página

MSW Motor Technics MSW-GDOOR-001A Manual De Instrucciones página 52

Publicidad

EN
PROGRAMMING INSTRUCTIONS
1. PROGRAMMING OPEN & CLOSE LIMITS
a) Press and hold SET buton to enter this func�on
se�ng un�l "1" appears on the display then
release the buton.
b) Press the SET buton again. The door opener is
now in Programming Mode. And then you will see
"n" with dot appears on the display.
c) Press and hold the UP buton un�l the door
reaches the desired open posi�on, you will see "n"
without dot on the display.
d) Press SET buton to confirm the open posi�on,
then you will see "u" with dot on the display.
e) Next press and hold the DOWN buton un�l the
door reaches the desired close posi�on, you will
see "u" without dot on the display.
NOTE: For fine adjustments toggle UP & DOWN
butons.
f) Now press the SET buton to confirm the close
posi�on, then you will see "II" on the display.
A�er confirming the close posi�on, the door will
now cycle open and close to set the travel limits
and force sensi�vity adjustments. The door is now
set for normal opera�on.
CAUTION:
After the cycle open and close, there will be figures
shown on the display (0~9), "0" means the doors is
balanced, the smaller figure means the better door
balance, strongly recommend that the figure need
to be smaller than the power force.

Publicidad

loading

Este manual también es adecuado para:

Msw-gdoor-003a