Publicidad
EN
5. AUTOMATIC CLOSING CONDITION SETTING
a) Press and hold SET Buton un�l "1" appears
on the display, next press the UP buton un�l
"5" appears on the display to enter this func�on
se�ng then release the buton.
b) Press the SET buton again. The unit is now in
automa�c close condi�on adjustment mode.
And then you will see a figure "1" with flash dot
appears on the display.
c) Press UP / Down buton once to set the auto
close condi�on. You can choose "1" or "2" set.
Figure "1" means, the door only can auto close
while in the open limit posi�on.
Figure "2" means, the door can auto close while
the door is in any posi�on.
d) Press SET buton to confirm the set and it will
back to standby status automa�cally and display
"ll".
NOTE:
1. The closing condi�on is set on "1" as standard
in factory.
2. The door will only automatic close while in its
opening process, but can't automatic close after
it is stopped while in its closing process.
1 – Increase
2 – Decrease
Publicidad
