Publicidad
EN
b. REVERSAL HEIGHT IGNORANCE SETTING
a) Press and hold SET Buton un�l "1" appears
on the display, next press the UP buton un�l
"b" appears on the display to enter this
func�on se�ng then release the buton.
b) Press the SET buton again. The unit is now
in reversal height ignorance adjustment mode.
And then you will see a figure "1" with flash dot
appears on the display.
c) Press UP / Down buton once to set the
reversal height ignorance while closing (0~9).
d) Press UP buton to increase, or DOWN
buton to decrease.
Figure 1~9 means the door will s�ll not
rebound even though there's obstacles in its
closing path within 1cm~9cm away from the
close posi�on. This func�on is most suitable
for the Northern Europe where will always
snow on the ground.
e) Press SET buton to confirm the set and it
will back to standby status automa�cally and
display "ll".
NOTE: The reversal height is set on "1"as
standard in factory.
1 – Increase height
2 – Decrease height
Publicidad
