Publicidad
EN
9. TRANSMITTER BUTTONS RECOGNITION
FUNCTION SETTING
a) Press and hold SET buton to enter this
func�on se�ng un�l "9" appears on the
display then release the buton.
b) Press the SET buton again. The unit is now
in butons recogni�on func�on adjustment
mode. And then you will see a figure "1" with
flash dot appears on the display.
c) Press UP / Down buton once to select if
you want all the 4 butons can control the only
one opener, or only the separate coded
buton can control the opener.
Figure "0" means the butons recogni�on
func�on is closed. It means if you coded 1
buton with 1 opener, then all the 4 butons
on the remote can control the opener. It's
suit for the users who only have 1
automa�on door at home.
Figure "1" means the butons recogni�on
func�on is open. If you coded first buton
with first opener, then the first buton will be
the only buton on the remote can control
the opener. It's suit for the users who have
more than 1 automa�on doors/gates at
home.
d) Press SET buton to confirm the set and it
will back to standby status automa�cally and
display "ll".
NOTE:
1. The butons recogni�on is set on "1" as
standard in factory.
2. After you changed the buttons un-
recognition into recognition, please notice
that only the coded button can control the
opener.
1 –
Butons recogni�on func�on is closed
2 –
Butons recogni�on func�on is open
Publicidad
