MSA PremAire Cadet Manual De Uso página 13

1. Connect the air-supply hose to the inlet.
3.7.1 Installing the Firehawk Regulator
WARNING!
DO NOT use a Firehawk slide-to-connect regulator with an Advantage 4000 Facepiece or a G1 Facepiece.
Failure to follow this warning can result in serious personal injury or death.
1. Push the release buttons on the regulator to ensure the regulator is shut off.
2. Open the bypass knob (counterclockwise), and ensure that air flows from the regulator.
3. Close the bypass knob (clockwise).
WARNING!
There must be a continuous flow of air when the bypass knob is opened. If not, do not use the respirator.
Failure to follow this warning can result in serious personal injury or death.
US
4. Grasp and orient the regulator so that red bypass knob is pointing to the right
and slide button is on top.
5. Slide the regulator onto the rail of the facepiece cover. Slide the regulator down
the rail until the regulator stops.
6. Insert the regulator into the facepiece inlet by pushing inward.
7. Ensure proper engagement by pulling on the regulator to verify that the regulator
is securely attached to facepiece.
PremAire Cadet
3 Donning
13