Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!
• Cleaning and disinfecting at or below 110°F (38°C) temperature will reduce the potential for overheating and
distortion of parts which would require replacement.
• DO NOT use any cleaning substances that can or might attack any part of the apparatus.
• DO NOT use alcohol because it may deteriorate rubber parts.
• DO NOT use cleaning products that contain hydrocarbons or solvents such as nitro-thinner.
• DO NOT use radiant heat such as the sun or radiators to dry cleaned parts.
• If a drying cabinet is used, make sure the temperature is not more than 140°F (60°C).
• If not rinsed thoroughly, cleaning agent residue may irritate the wearer's skin.
• Ensure there is no water, moisture, or dampness on or in the facepiece and regulator before returning it to service.
• Failure to clean and decontaminate the respirator correctly after each use can cause overexposure to contamination
and result in illness, disease, or death.
Failure to follow these warnings can result in serious personal injury or death.
NOTE: If a decontamination procedure, created by a certified health and/or safety professional, has been established for
the application in which this respirator is used, that procedure should take precedence.
5.1
Cleaning and Disinfecting the Facepiece
US
1. Remove the facepiece mounted regulator from the facepiece.
2. Prepare a bucket or sink with Confidence Plus Cleaning Solution as described
on the container.
3. The head harness can be removed to separate cleaning or as part of the
facepiece.
4. Submerge the facepiece in Confidence Plus Cleaning Solution for a minimum of
30 seconds. A soft brush or sponge can be used to clean the soiled facepiece.
PremAire Cadet
5 Cleaning and Disinfecting
19
Publicidad
