Calpeda NCE HQ2 Instrucciones De Uso página 47

10.2 Fault Cause and Finding
Alarm Codes
F0
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11
F12
F13
F14
F15
F16
Auto reset
Fault
& restart
-
YES
YES
YES
YES
-
-
YES
YES
-
-
-
-
YES
YES
-
-
46
Exclusion method
Contact the after-sales department
The alarm is automatically cleared
within 30s, confirm whether the
fault still exists.
The alarm is automatically cleared
within 30s, confirm whether the
fault still exists.
The alarm is automatically cleared
within 30s, confirm whether the
fault still exists.
Contact the after-sales department
Clean the pump and remove any
foreign objects or impurities that
prevent the pump from rotating.
Contact the after-sales department
The alarm is automatically cleared
within 30s, confirm whether the
fault still exists.
The alarm is automatically cleared
within 30s, confirm whether the
fault still exists.
Check whether the input voltage
frequency is 50Hz±3Hz,
or 60Hz±3Hz.
Check if the input voltage is too high.
Check if the input voltage is too low
Contact factory for repair.
The alarm is automatically cleared
within 30s, confirm whether the
fault still exists.
The alarm is automatically cleared
within 30s, confirm whether the
fault still exists.
To check whether is there water
on the pump when running
To check if the sensor is in
working order
GB