Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Year selection will scroll up from 2017. Month selection will scroll from 1 to 12. Day selection
will scroll from 1 to 31.
Note: Hour selection will scroll through 0 to 23. Minute and Second selections will scroll through 0 to
59.
Note: If batteries are removed from wrench for longer than 20 minutes, clock will revert to default
settings and must be re-entered at power on.
Setting Calibration Interval
This function will allow user to set calibration interval for when "CAL NEEDED" message will be
displayed.
1. From Configure menu, use UP
press ENTER
button.
2. CAL INTERVAL screen is displayed.
3. Use UP
/DOWN
Selectable Intervals:
DISABLED (factory default)
3 MON
6 MON
12 MON
4. Press ENTER
button to accept selection and exit to Configure menu.
DELETE PRESETS
CALIBRATION
SET DATE/TIME
SET CAL INTRVAL
ENTER
button
Note: Clock Date and Time must be set before calibration interval will function. If batteries are removed
from wrench for longer than 20 minutes, clock will revert to default settings and must be re-
entered at power on.
Note: Calibration interval is calculated from either In-Service Date or last Calibration date (see SHOW
INFO menu) depending on which is more recent date. When clock Date is greater than In-Service
or Last Calibration date, plus Cal Interval, "CAL NEEDED" message will be displayed on power up
and after a re-zero. Pressing ENTER
"CAL NEEDED" message is displayed will immediately display torque or angle measurement and
return to target menu when released.
Note: As an alternative to calibration interval, a Calibration Cycle Counter is provided in Calibration
menu (Contact your local Snap-on Repair Center regarding Calibration menu).
/DOWN
buttons to change calibration interval.
CAL INTRVAL
ENTER
button
DISABLED
EXIT
UP/DOWN buttons
CAL INTRVAL
12 MON
EXIT
buttons to highlight
button will continue to target menu. Applying torque while
20
SET CAL INTRVAL
selection then
Publicidad
