Publicidad
Idiomas disponibles
Idiomas disponibles
User Instructions
Basic Functions (Quick Start)
TORQUE AND/OR
BATTERY
PROGRESS
CONDITION
LIGHTS
DATA
STORAGE
ALERT
Wrench Power On Sequence
Note: Do not turn on wrench while torque is applied, otherwise torque zero offset will be incorrect
and wrench will indicate a torque reading when torque is released. If this occurs, re-zero
wrench by momentarily pressing POWER
torque applied.
1. Turn On Wrench.
Momentarily press POWER
zeroing screen. If previous measurement was angle measurement, then angle re-zeroing
screen follows the torque zeroing screen. After re-zeroing, the target torque or target angle
screen is displayed depending on previous measurement mode.
2. Select Measurement Mode.
Toggle between target TORQUE and ANGLE screens by repeatedly pressing
ENTER
button.
ON/OFF
AND
ANGLE DISPLAY
RE-ZERO
MODE
COUNT
PROGRESS
UNITS AND
LIGHTS
PRESET ENTRY
BUTTON
Install three fresh "AA" cells into wrench handle.
TORQUE ZEROING
250.0
Target Torque Screen
ANGLE ZERO REQ
PROGRESS LIGHTS
Yellow - First light indicates 40% of target torque
Green - Indicates target torque or angle reached.
Red
INCREMENT
BUTTON
LCD BACKLIGHT
DECREMENT
BUTTON
PEAK TORQUE/ANGLE
RECALL BUTTON
Figure 1
button while wrench is on a stable surface with no
button. Snap-on logo is displayed followed by torque re-
00
ENTER
button
FT-LB
ENTER
button
3
or angle reached, Second indicates 60%
of target reached, Third indicates 80% of
target reached.
- Indicates exceeded torque or angle
target+4% for targets above 20% to
100% of F.S. or target+10% for targets
from 5% to 20% of F.S, or exceeded
MAXIMUM Preset target (Note: Yellow
lights also turn on with red).
MODE SELECT, MENU ENTRY AND ENTER BUTTON
AUDIBLE ALERT
AND
ANGLE ZEROING
--
SET STILL
00
180°
Target Angle Screen
Publicidad
