Publicidad
Idiomas disponibles
Idiomas disponibles
340 Nm wrench:
Maximum Target Torque =
offset * 0.64 + 340
Offset
Max Target
-1"
-2"
-3"
-4"
Note: When using a negative offset, entering a target torque greater than maximum values above may
cause an overtorque error before reaching fastener target torque and possibly damage wrench.
Viewing Stored Torque and Angle Data
Torque data is stored in memory after each torque cycle if applied torque has reached target value.
Torque and angle data is stored in memory after each angle cycle if applied angle has reached target
value. Memory Indicator is displayed when data is stored in non-volatile memory.
1. To view stored torque and angle data, from target torque or angle screen, press and hold
ENTER
button for 3 seconds.
2. Highlight
SHOW DATA
ENTER
button to display Show Data screen.
3. In Show Data screen, scroll through each stored data record by pressing UP
Example: 02 = Show Data List Counter: TQ = Peak torque value
01 = Show Data List Counter: TQ = Peak torque value: ANG = Peak angle value
4. Pressing ENTER
00
100.0
FT-LB
M
Target Screen
Note: A maximum of 50 data records can be stored in memory. Memory full icon will be displayed when
full. New data will replace oldest record until memory is cleared.
Deleting Stored Torque and Angle Data
1. From target torque or angle screen, press and hold ENTER
2. Highlight
CLEAR DATA
to display CLEAR ALL DATA screen.
3. In CLEAR ALL DATA screen, highlight
selection to exit without deleting data.
4. Press ENTER
button after making selection.
324 Nm
-25 mm
308 Nm
-50 mm
292 Nm
-75 mm
276 Nm
-100 mm
menu selection by pressing UP
button while on Show Data screen returns to main menu.
ENTER
EXIT
button
SET HEAD LENGTH
held
SHOW DATA
CLEAR DATA
M
UP/DOWN buttons
EXIT
SET HEAD LENGTH
SHOW DATA
CLEAR DATA
M
menu selection using UP
400 Nm wrench:
Maximum Target Torque =
offset * 0.63 + 400
Offset
Max Target
384 Nm
369 Nm
353 Nm
337 Nm
02:
ENTER
button
TQ: 100.2 FT-LBS
M
01:
TQ: 100.3 FT-LBS
ANG: 84°
M
/DOWN
YES
menu selection to delete all stored data, or
7
/DOWN
buttons then press
02:
2019/09/26
OR
TQ: 100.2 FT-LBS
M
UP/DOWN buttons
01:
OR
TQ: 100.3 FT-LBS
ANG: 84°
M
button for 3 seconds.
buttons then press ENTER
/DOWN
buttons.
15:40:15
If clock has
been set data
timestamp will
be displayed
(see Advanced
Configuration).
15:35:05
2019/09/26
button
NO
menu
Publicidad
