Publicidad
Idiomas disponibles
Idiomas disponibles
Mode Cycle Count
TechAngle
®
mode cycle count feature is used to indicate number of
times wrench has reached target torque in torque measurement
mode or target angle in angle measurement mode.
Torque and Angle Mode Cycle Counting
1. Numerical counter located in top right of target torque or target angle screen will increment after
each torque or angle cycle if applied torque or angle has reached target value.
2. When toggling between torque mode and angle mode using ENTER
numerical counter will reset back to 00. Counter WILL NOT reset when re-zeroing, on menu
entry/exit or power down.
3. Memory icon will turn on indicating at least one torque or angle cycle data has been stored in
memory.
Main Menu
Main menu displays wrench operational information.
1. From target torque or angle screen, press and hold ENTER
2. Use UP
/DOWN
Menu Selections:
EXIT - Exits Main menu and returns to target screen.
SET HEAD LENGTH - Displays wrench head length entry screen.
SHOW DATA - Displays stored torque and angle data.
CLEAR DATA - Clears stored torque and angle data.
CYCLE COUNT - Displays torque/angle cycle count screen.
LANGUAGE - Displays language selection menu.
SETTINGS - Displays advanced settings menu (see Advanced Settings Section).
CONFIGURE - Displays advanced configuration menu (see Advanced Configuration Section).
3. To exit Main menu and return to target torque or angle screen, press ENTER
menu selection is highlighted.
Setting Head Length
Note: If an adapter or extension is added to wrench, length of adapter/extension being used can be
entered to correct for a different length than head used to calibrate wrench without requiring
re-calibration.
1. To enter a head length, from target torque or angle screen, press and hold ENTER
seconds.
2. With
SET HEAD LENGTH
3. Set Head Length screen is displayed next. Default head length is length of head at calibration (zero
for fixed head wrench) and is displayed with most-significant digit highlighted. Use UP
buttons to increment/decrement head length. Pressing and holding UP
will progressively increment/decrement value faster.
4. Press ENTER
button to accept digit and highlight next-significant digit.
5. Default units of length is in inches. Press UNITS
6. Pressing ENTER
changed from default, "OFFSET IN USE" message will be displayed whenever wrench is re-zeroed.
Pressing the ENTER
offset is in use.
Note: If UP
/DOWN
displayed head length resets to zero.
buttons to highlight menu selection then press ENTER
menu selection highlighted, momentarily press ENTER
button after least-significant digit is set returns to main menu. If length is
button will display target screen with target highlighted in black to indicate
buttons are pressed simultaneously while on the Set Head Length screen,
MEMORY ICON
button for 3 seconds.
U
button to change to millimeters.
5
180°
M
MODE CYCLE
button or if target is changed,
button.
button while
button for 3
button.
/DOWN
01
COUNT
EXIT
/DOWN
buttons
Publicidad
