Angelo Po MS1 Breves Instrucciones Para La Instalación Y Uso página 24

Chapter 4. Safety standards
•
Never use the machine in the event of fault.
•
Never tamper with safety devices or circuits.
•
Never perform modifications on the machine without prior authorisation from the manufacturer.
•
If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or
its service agent.
•
The electrical enclosure must remain closed during operation.
•
Smoking is forbidden while the machine is operating!
•
Never performs maintenance and/or adjustments to the machine during operation. Guards may only be
disassembled by suitably trained and qualified maintenance engineers.
•
Never operate the machine without all guards fitted. Ensure correct position of all guards before resuming normal
operation.
•
If it is necessary to leave the machine unattended, switch it off by turning the main switch to the "0" (OFF) position!
•
The manufacturer declines all liability for damage or phisical injury caused by failure to observe safety standards.
THE MACHINE CAN NOT BE USED BY UNTRAINED PERSONNEL!
During work pay attention to all hot parts of the machine. The temperature they can reach is so high
that it can cause burns.
Never use gaseous mixtures in presence of oxygen in a percentage higher than the atmospheric one
(~ 19%).
Do not touch the sealing blade (16) immediately after sealing.
Danger of burns due to hot blade.
Do not seal if the sealing wire is broken.
Replace it immediately.
Do not touch the vacuum pump (23) just after a working cycle.
Possibility of burning due to the high temperature the pump
may reach.
In case of a power failure during a working cycle when the
cover is closed, do not use any tool in order to force its opening.
Wait for the power supply to be restored.
Do not place any weight on the cover (18)!
Prevent any object from falling on the cover!
This can compromise the integrity, causing cracks or damage.
Do not proceed with packaging if the cover has cracks or is
broken.
Replace it immediately.
23
EN