Publicidad
Idiomas disponibles
Idiomas disponibles
Chapter 4. Safety standards
4.2. Description of safety stickers
The following safety stickers feature on the machine:
On the power input.
ATTENTION! Periodically check the correct insulation of the power cable and the integrity of the
socket. During machine operation, the inspection panels to the electric system must be correctly
fitted.
On the sealing bars positioned inside the tank
On the vacuum pump positioned inside the machine.
ATTENTION! Hot members. It shows the danger of burning, thus involving the risk of a serious
accident for the exposed person.
4.3. Individual protection devices
Wear safety shoes that protect feet from impacts, crushing and compression while moving or handling the
machine.
Wear safety gloves that protect the hands from crushing and mechanical hazards and while moving or
handling the machine.
Wear safety gloves that protect the hands against cutting risks while changing the sealing blades.
Wear safety gloves that protect the hands against the specific risks associated with the materials to be
packed (mechanical, chemical) and against coming into contact with the high temperatures present on the
seals and/or sealing bars (up to 100°C).
Wear safety gloves that prevent the hands from coming into contact with foodstuffs when
packaging them.
Chapter 5. Machine installation
5.1. Transport and positioning
• When transporting and positioning the machine, it is recommended to handle it with great care!
• Neither overturn nor tilt the machine! Oil might come out of the pump and damage the machine.
Cut the strap with scissors make sure you protect your eyes by wearing glasses and withdraw the cardboard. Cut the
strap fastening the machine to the pallet.
5.2. Environmental conditions
•
Lift the machine and place it on the working surface. Make sure the machine is placed in a proper environment
without any inflammable and explosive materials or gas. The machine may only be installed on smooth, flat non-
inflammable surfaces.
•
Leave a minimal space of 0,5m around the machine so that not to obstruct air outlets.
Working environmental conditions:
•
Temperature from + 5°C to + 40°C.
•
Relative humidity from 30% to 90%, without condensation.
The lighting of the operation room shall comply with the laws in force in the country where the machine is installed.
However, it shall be uniform and provide for good visibility in order to safeguard the operator's safety and health.
MACHINE SAFETY FACTOR = IP20
THE AERIAL NOISE MADE BY THE MACHINE IS LOWER THAN 70 dB(A)
On the sealing bars positioned inside the tank
ATTENTION! Indicates the danger of burns with risk of accident in case of
contact with the hot surface of the sealing bar.
On the Plexiglas lid.
ATTENTION! Indicates how to clean the lid to prevent damaging it and reducing
its transparency or strength.
24
EN
EN
Publicidad
