Publicidad
Idiomas disponibles
Idiomas disponibles
Chapter 6. Machine adjustment and setting up
6.3. Selecting the programs and setting up the parameters
The machine has 10 selectable programs:
P1, P2, P3, P4: standard programs
P5: program for "outside vacuum"
t1, t2, t3, Sr1, Sr2: special programs.
To select the program number, just press the buttons INCREASE (6) and DECREASE (7).
Press button (4) to enter scheduling of the program shown at the moment. By pressing again button (4), all parameters fo
the selected program will appear one after the other.
Push buttons (6) and (7) to increase or decrease the value of the parameter shown.
To store modifications, after viewing all the parameters, press for a few seconds button (4). The display flashes and
when the program no. is displayed (e.g. P1) this means the new data have been saved.
Note: during the programming stage the Stop (8) button lets you go back to the previous parameter.
6.3.1. Standard programs P1, P2, P3, P4.
,
,
Parameter "Vacuum"
It is possible to set a value from 35.0 to 99.9%. The recommended vacuum percentage is 99.9%.
For other settings refer to the attached table.
Scheduling of vacuum parameter is signaled through LED (9).
Food
Meat
Cheese
Grated cheese
Fruit
Jam and cream
Soups
Sandwiches
Pasta
Fish, shellfish
Sausages
cured meats
Vegetables
Fresh vegetables (salad, tomatoes)
Parameter "Extravacuum"
If the vacuum value is set to 99.9%, press button (4) to program the EXTRAVACUUM parameter indicated by the letter E
in the last digit on the display.
This value can be set to between 0 and 60 seconds. This the length of time that the pump continues to extract air from
the hood after the machine has reached the programmed maximum vacuum level. This function is useful for porous
products where it is particularly difficult to extract the air (e.g. meat).
Note: if the programmed VACUUM value is less than 99.9%, the EXTRAVACUUM function is not displayed, and the
system proceeds to the subsequent parameter (GAS).
Parameter "Gas"
It is possible to set a value from 0 to 60%. Such a parameter cannot be higher than the vacuum one, otherwise you will
obtain an opposite function. Scheduling of gas parameter is signaled through LED (10). If the gas LED (10) is flashing, it
means the gas cylinder is not properly connected and machine will not start. Connect it properly.
Note: When scheduling a program "vac + gas", the minimum residual vacuum percentage soon after gas immission
should be higher than 60%.
Example:
VAC 99.9%
GAS 40%
Residual vacuum (99.9 - 40)= 59.9%
Parameter "Sealing"
It is possible to set a value from 0.5 to 4 seconds. For the first working cycles it is recommendable to set a sealing time of
about 1.6 seconds and then lower it to prevent the teflon tape from burning. Scheduling of sealing time parameter is
signaled through LED (11).
These are standard programs consisting of 4 modifiable parameters:
,
vacuum, extravacuum, gas, sealing.
Vacuum
Recommended
99.9%
99.9%
35 - 50%
99.9%
99.9%
99.9%
60 - 70%
99.9%
99.9%
99.9%
99.9%
99.9%
35 - 50%
27
EN
Publicidad
