Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Preparation
• Place the appliance near a water inlet or drain and a power socket.
• Make sure that the hoses and the plug are accessible at all times.
Setting up the unit
Place the unit in the preferred location. The back should face the wall, the sides towards
the built-in cupboard or a wall. The dishwasher is equipped with a water drain that can
be directed to the right or the left to facilitate installation.
Power connection
Do not use an extension cord or adapter. Make sure that the socket is earthed and
complies with local regulations. Only connect the appliance to sockets that correspond
to the specified voltage of the appliance. If the plug does not fit the socket, have it
replaced by a professional.
Attach and remove the water inlet
Use new hoses for the connection. Do not use old hoses. The water pressure must be
between 0.04-1 MPa. If the pressure is lower than this, ask a specialist company for
advice.
• Attach the inlet hose: Completely unwind the
safety inlet hose from the bracket on the back of
the appliance. Attach the screw to a ¾ inch water
tap. Turn on the water supply fully before use.
• Remove the supply hose: Close the water supply.
Unscrew the inlet hose from the water tap.
Note: Make sure the screw is tight on the tap. If you have never used the connection
before or have not used it for a long time, drain some water beforehand until clear
water comes out of the tap. These precautions ensure that the inlet valve does not
become clogged or damaged by particles in the water.
EN
45
Publicidad
