Publicidad
Idiomas disponibles
Idiomas disponibles
EN
To remove the upper spray arm,
hold the nut in the middle and turn
the spray arm anticlockwise to
remove it.
64
Spray arms
The spray arms must be cleaned regularly as hard water causes limescale residues to
adhere to the spray arms and the brackets. Follow the instructions below for cleaning the
spray arms:
Pull the upper spray arm upwards
so that you can remove the lower
spray arm.
Frost protection
Take the following frost protection measures in winter and proceed as follows after each
cleaning cycle:
1.
Disconnect the power plug of the dishwasher from the socket.
2.
Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the water inlet pipe and the water valve (collect it in a bucket).
4. Reconnect the water inlet line to the water valve.
5. Remove and clean the filters.
After each wash
Turn off the water supply and leave the door slightly open so that the moisture and
odours do not remain inside the appliance.
Place the spray arms in a soap
solution with warm water and use
a soft brush to clean the nozzles.
After carefully rinsing the spray arms
with water, put them back into the
appliance.
Publicidad
