Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Water hardness
°dH
1)
0-5
6-1 1
12-17
18-22
23-34
35-45
50
Please note:
• The salt only needs to be topped up when the salt warning light comes on.
Depending on how well the salt dissolves, the salt warning light may remain on for
some time after the salt container has been filled. If your appliance does not have
such a warning light (on some models), you can estimate the moment when you
need to refill the salt depending on the frequency of use of the dishwasher.
• If salt has spilled, run a quick programme to remove it.
Setting the correct salt quantity
The dishwasher is designed in such a way that the amount of salt used can be adjusted
depending on the water hardness. This is to optimise and individually adjust salt
consumption. Proceed as follows to set the salt consumption:
1. Close the door and switch on the appliance;
2. Within 60 seconds after turning on the device, press the programme button for
more than 5 seconds to start the water softener setting mode.
3. Press the programme button again to select the correct setting according to your
local water hardness. The setting changes in the following order: H1 > H2 > H3 >
H4 > H5 > H6.
4. If you do not operate the device for five seconds or press the power button to exit
the setting mode, the setting made will be saved.
Softener setting
mmol/l
2)
0-0.9
1.0-2.0
2.1-3.0
3.1-4.0
4
4.1-6.1
6.2-8.0
¹ German hardness level
² International hardness level
Each cycle with regeneration operation uses an additional 2.0 litres of water. The
3
energy consumption increases by 0.02 kWh and the programme duration is extended
by 4 minutes.
Factory setting
*
Display indications
1
2
3
*
5
6
Regeneration after
every Xth program
sequence
H1
No regeneration
H2
H3
H4
H5
H6
3
10
5
3
2
1
Publicidad
