Balluff BML SL1-ALZ-ZZ Serie Manual De Instrucciones página 82

BML SL1-ALZ _-_ _ ZZ- _ _ _ _ - _ _ _ _
Absolute Magnetically Coded Position Measuring System
7
IO-Link Smart Sensor profile Ed. 2 (BML SL1-ALZ1-UE/MZZ-_U1L-...) (continued)
7.5.2 Switching Signal Configuration (SSC)
Before beginning the switching signal
configuration the measurement value
configuration (see Section. 7.5.1) must be
completed!
4 switching signals are integrated in the BML. Each
switching signal is described by the two parameters
(Parameter and Configuration). The BML has converted
the switching signals as window mode according to the
Smart Sensor profile.
Hysteresis
SSC
OFF ON
SP1
Fig. 7-2: SSC hysteresis
Parameters
SSC Parameter
SSC1: 0x003C (60)
SSC2: 0x003E (62)
SSC3: 0x4000 (16384)
SSC4: 0x4002 (16386)
SSC Configuration
SSC1: 0x003D (61)
SSC2: 0x003F (63)
SSC3: 0x4001 (16385)
SSC4: 0x4003 (16387)
Tab. 7-8: Parameter data SSC
In SIO mode SSC1 and SSC2 are set to the
outputs OUT1 and OUT2.
The BML supports Single-Teach functions in accordance
with the Smart Sensor profile. For this Teach-In procedure
two additional parameters are used (TI Select and TI
Result, see Tab. 7-9).
Index
TI Select
0x003A (58)
TI Result
0x003B (59)
Tab. 7-9: Parameter data Teach In
30 english
Hysteresis
OFF
Measured
SP2
value
Subindex Name
1 Setpoint 1 (SP1)
2 Setpoint 2 (SP2)
1 Logic
2 Mode
3 Hysteresis
Subindex Size Access
0 1 byte Read/Write 0 or 1 = SSC1 (default)
0 1 byte Read Only
Size Access Values
4 bytes Read/Write 32-bit integer value [µm]
4 bytes Read/Write 32-bit integer value [µm]
0 = Normally open (no, default)
1 byte Read/Write
1 = Normally closed (nc)
0 = Disabled
1 byte Read/Write
2 = Window mode (default)
2 bytes Read/Write 100...30000 μm (default: 100 µm)
Values
2 = SSC2
3 = SSC3
4 = SSC4
0x00 (0) = inactive
0x11 (17) = Teach-In of SP1 successful
0x42 (66) = Teach-In of SP2 successful
0x07 (7) = Error