Panasonic NE-SCV3 Instrucciones De Uso página 8

Care of your Oven
QCooking Plate • Oven Sheet • Paddle
Wash with a sponge scrubbing brush with (neutral) detergent for use in the
kitchen applied to it.
If you are concerned about stains, clean the equipment every time you use it.
Do not wash the equipment in a dishwasher.
O
If you are concerned about bad oil stains or the like
O
Use alkaline detergent. When using alkaline detergent, use after thoroughly reading the detergent's usage
cautions. After performing the maintenance, make sure you wipe the equipment with a damp cloth so no
detergent remains.
However, you cannot use this on the inside of the door as the resin parts will deteriorate. If by chance the
detergent should get on the resin parts, wipe them with a damp cloth immediately.
Disassemble and clean this part Every Day.
Q Drip Tray
Wipe with a damp cloth
Refer to "How to remove/attach parts". (p.15)
O
Disassemble and clean these parts Once a Week.
Refer to "How to remove/attach parts". (p.15)
O
Do not wash the equipment in a dishwasher.
O
Q Front Cover Wipe with a damp cloth
Wipe away oil and food stains immediately.
If the stains are bad, wipe away with a cloth soaked in a neutral kitchen
detergent.
Q Air Filter Dry after washing with water
Clean it after every use it if the stains are bad.
The filter may lose its effect if the stains are left behind.
The temperature of the internal parts may also rise, resulting in a malfunction.
Q Oil Tray
Wipe away oil stains with a soft cloth or paper towel
If the stains are bad, clean the area with a soft scrubber dipped in a neutral
kitchen detergent and dry.
14
Q How to remove/attach parts
Front Cover/Air Filter
Removing
O
After pulling the front cover down toward you, lift it diagonally upward to remove it.
Remove the air filter by pulling it out of the front cover.
Attaching
O
Insert the air filter into the groove of the front cover, and after firmly inserting it all the way in, install it so
that the groove of the front cover is inserted into part Ⓐ Ⓐ of the main unit.
Groove
Drip Tray
Removing
O
Pull the drip tray toward you to remove it.
Oil Tray
Removing
O
Remove the front cover first, and take out the oil tray.
Attaching
O
Follow the reverse procedure to install the oil tray.
Clean this part once a month.
QExhaust Vent
Clean the rear exhaust vent with
a toothbrush and a towel
Air Filter
Groove Groove
Ⓐ Ⓐ
Q If the air filter is not set, the front cover will not close.
Attaching
O
Install the drip tray so that its groove slots into part Ⓑ Ⓑ
of the main unit.
Ⓑ Ⓑ
Groove Groove
15