SYSTEM UTILITIES (CONTINUED)
7.
Press the Up and Down Arrow buttons to highlight
Edit Stim.
8.
Press the Enter button to accept the selection.
The waveform's parameters display.
9.
Press the Up and Down Arrow buttons to highlight the
parameter you want to change and adjust it accordingly,
making sure to press the Enter button after each
adjustment.
10. Press the Up and Down Arrow buttons to highlight Edit
Ultrasound.
11.
Press the Enter button to accept the highlighted selection.
The Ultrasound parameter screen displays.
12. Press the Up and Down Arrow buttons to highlight the
parameter you want to change and adjust it accordingly,
making sure to press the Enter button after each
adjustment.
13. Press the Clinical Library button.
The Save Protocol screen displays.
14.
Use the Up Arrow and Down Arrow buttons to highlight
Save as Default protocol. This will become the protocol
displayed when Ultrasound is selected on the Home
screen.
15. Press the Enter button to accept the highlighted selection.
The Default Protocol Confirmation window displays.
16.
Press any key to confirm the settings.
You are returned to the Clinical Library menu.
Restoring Factory Protocols
If necessary, you can choose to restore the unit's original
(default) waveform parameters when it was shipped to you.
NOTE: This procedure will erase all user-defined protocols.
To restore the unit's original waveform parameters, do the
following:
1.
On the Home screen, press the Clinical Library button.
The Clinical Library window displays.
2.
Press the Up Arrow or Down Arrow buttons to highlight
Restore Factory Protocols.
3.
Press the Enter button to accept the highlighted selection.
The unit displays the message "Restoring Protocols
Please wait. "
The user-defined protocols are erased and the waveforms
are restored to the original parameters. Then the Restore
Factory Protocols Confirmation window displays.
4.
Press any button on the Operator Interface.
You are returned to the Clinical Library window.
OPERATION
37