Publicidad
Idiomas disponibles
Idiomas disponibles
Programming
LCD Icons and States
Icon locations on display
Connected to Wi-Fi
Not connected to Wi-Fi
1. Solid if connected to myQ server
2. Blinks if NOT connected to myQ
server
No battery
Battery charging
Battery fully charged
Quick Start Commissioning
Follow the below instructions to provision the TDC
operator out-of-the-box or after factory reset:
Follow device menu prompt to set OPEN LIMIT
Follow device menu prompt to set CLOSE LIMIT
Follow device menu prompt to LEARN WIFI
The operator will be in WiFi Learn Mode for 10 minutes if
"YES" is selected.
Manual Commissioning Program Flow
IMPORTANT: All entrapment protection devices will be disabled during the manual commissioning steps.
All menu options under "System Settings" are password protected
ENTER PROGRAMMING
1.
Simultaneously, press & hold the "Stop/Enter" and "Down" buttons for 3+ seconds to enter the operator menu. If
the controller is closed, press the "Stop" then "Close" then "Open" until the unit goes into program mode.
2.
Scroll down to "SYSTEMS SETTINGS" with the "UP" and "DOWN" buttons and press"Stop/Enter." You will be
prompted to enter the password for the operator.
3.
Enter 326 as the password.
DOOR
SELECT DOOR TYPE
SETTINGS
STANDARD LIFT
myQ
SELECT DOOR TYPE
HIGH LIFT
WARNING
To prevent possible SERIOUS INJURY or DEATH:
•
Disconnect electric power BEFORE performing ANY
adjustments or maintenance.
•
ALL maintenance MUST be performed by a trained door
systems technician.
•
Please wait several seconds for capacitors to discharge and
for display to go out.
Quick Start Commissioning
Follow the below instructions to provision the JDC/JHDC
operator out-of-the-box or after factory reset:
Quick Start Commissioning Menu
Follow device menu prompt to select DOOR HANGING
Follow device menu prompt to select DOOR DRUM
Follow device menu prompt to select DOOR SPROCKET
(J/H ONLY)
Follow device menu prompt to set OPEN LIMIT
Follow device menu prompt to set CLOSE LIMIT
Follow device menu prompt to LEARN WIFI
The operator will be in WiFi Learn Mode for 10 minutes if
"YES" is selected.
Quick Exit of Menu
Simultaneously, press & hold the
"UP" and red "Stop/Enter buttons
for 3 seconds until the screen goes
blank and it will exit you out of the
menu you are in.
Quick Enter into the Menu
Simultaneously, press & hold the
"Down" and red "Stop/Enter buttons
for 3 seconds until the screen goes
blank and it will take you to the
main menu.
SELECT DOOR TYPE
VERTICAL LIFT
29
SELECT DOOR TYPE
ROLLING
Publicidad
