Publicidad
Idiomas disponibles
Idiomas disponibles
Safety Information
Safety Symbols and Signal Word Review
WARNING
WARNING
When you see these Safety Symbols and Signal Words
on the following pages, they will alert you to the possibility
of serious injury or death if you do not comply with the
warnings that accompany them. The hazard may come
from something mechanical or from electric shock. Read
the warnings carefully.
CAUTION
When you see this Signal Word on the following pages,
it will alert you to the possibility of damage to your door
and/or the door operator if you do not comply with the
cautionary statements that accompany it. Read them
carefully.
WARNING: This product can expose you to chemicals including lead, which are known to the State of
California to cause cancer or birth defects or other reproductive harm. For more information go to www.
P65Warnings.ca.gov.
To reduce the risk of SEVERE INJURY or DEATH:
1.
READ AND FOLLOW ALL INSTALLATION WARNINGS
AND INSTRUCTIONS.
2.
Install door operator ONLY on properly balanced
and lubricated door. An improperly balanced door
may NOT reverse when required and could result in
SEVERE INJURY or DEATH.
3.
ALL repairs to cables, spring assemblies and other
hardware MUST be made by a trained door systems
technician BEFORE installing operator.
4.
Disable ALL locks and remove ALL ropes connected
to door BEFORE installing operator to avoid
entanglement.
5.
Install an operator, a minimum of 8 feet (2.44 m) from
the floor.
6.
NEVER connect a door operator to a power source
until instructed to do so.
7.
NEVER wear watches, rings or loose clothing while
installing or servicing an operator. They could be
caught in the door or operator mechanisms.
Mechanical
Electrical
IMPORTANT NOTES:
•
BEFORE attempting to install, operate or maintain
the commercial door operator, you must read and
fully understand this manual and follow all safety
instructions.
•
DO NOT attempt repair or service of a commercial
door operator unless you are an Authorized Service
Technician.
•
A commercial door operator should only be installed
on a properly balanced door. Ensure door is properly
balanced prior to installation.
ENTRAPMENT PROTECTION DEVICES
Monitored Entrapment Protection
Monitored photoelectric sensors and/or door edge
sensors are required for any momentary contact to close
modes of operation. See "Entrapment Protection" section
for additional information. Refer to the Entrapment
Protection Devices in "Accessories" section for available
options.
WARNING
8.
Install a wall controller:
• within sight of the door.
• out of reach of small children and at a minimum
height of 5 feet (1.5 m) above floors, landings,
steps, or any other adjacent walking surface.
• away from ALL moving parts of the door.
9.
Install the wall controller far enough from the door
to prevent the user from coming in contact with the
door while operating the controls.
10. Install the entrapment warning placard on the wall
next to the wall controller in a prominent location,
visible from the door.
11. Place the manual release/ safety reverse test label in
plain view on the inside of door.
12. Upon completion of installation, test the entrapment
protection device(s).
13. This door operator is not intended to replace door
locks. With enough force, a door without a door lock
can be opened. LiftMaster always recommends the
use of door locks to properly secure a door.
14. SAVE THESE INSTRUCTIONS.
3
Publicidad
