Publicidad
IMPORTANT 2
If the apparatus is fitted with AC mains power outlet(s),
see
REAR
PANEL
FACILITIES
for
convenient
connection of additional Hi-Fi componentis). Make ali
connections to the AC outlet(s) and the signal terminals
first. Connect the plug to the wall socket last, make
sure that the power switch is off.
FOR USE IN THE UNITED
KINGDOM
The
wires
in this mains
lead are
coloured
in
accordance with the following code:
Biue:
Neutral
Brown:
Live
As the colours of the wires in the mains lead of this
apparatus
may
not correspond
with the coloured
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or
coloured black.
The wire which is coloured brown must be connected
to the terminal which is marked with the letter L or
coloured red.
Neither wire is to be connected to the earth terminal
of a three pin plug.
Equipment sold in the U.K. is not supplied with a power
plug.
marking identifying the terminals in your plug proceed
as follows:
[FOR EUROPEAN
AND U.K. MODELS]
CAUTION
This product contains a laser diode of higher class
than 1. To ensure continued safety, do not remove
any covers or attempt to gain access to the inside of
the product.
Refer all servicing to qualified personnel.
The following caution label appear on your player.
Location: rear of the player
CLASS 1
LASER PRODUCT
VRW-328
"This product complies
with the Radio Interference
require-
ments of the EC (European Community) Directive 87/308/EEC."
Thank you for buying this Pioneer product.
Please read through these operating instructions so you will
know how to operate your model properly. After you have
finished reading the instructions, put them away in a safe
place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown
in the explanatory drawings. However, the method of con-
necting and operating the unit is the same.
2
<PRE1117>
En
POWER-CORD CAUTION
Handle the power cord by the plug. Do not pull out the plug by tugging
the cord and never touch the power cord when your hands are wet as
this could cause a short circuit or electric shock. Do not place the unit,
a piece of furniture, etc., on the power cord, or pinch the cord. Never
make a knot in the cord or tie it with other cords. The power cords
should be routed such that they are not likely to be stepped on. A
damaged power cord can cause fire or give you an electrical shock.
Check the power cord once in a while. When you find it damaged, ask
your nearest PIONEER authorized service center or your dealer for a
replacement.
Publicidad
