Publicidad
Idiomas disponibles
Idiomas disponibles
Pump installation
The AECP pump can be mounted vertically
(→ Fig. 2) or horizontally (→ Fig. 3)
Horizontal installation utilizes 4x through
holes Use a bracket approximately
thick and 3 5 in
/
-20 bolts with vibration
1
4
resistant hardware
NOTE
Do not use
1
/
20 bolts shorter than 3 5 in
4-
Failure to comply may result in damage to
equipment and loss of warranty
Vertical installation utilizes 4x
mounting holes Use a bracket approxi-
mately
/
in thick with 1 5 in
1
1
8
and appropriate lockwashers
NOTE
Do not use
/
20 bolts shorter than 1 5 in
1
4-
Failure to comply may result in damage to
equipment and loss of warranty
A bracket kit is available and must be
ordered separately
Install pump with enough clearance to
allow access for purging valve and ease of
access to replace cartridge
Location must be high enough and wide
enough to remove grease cartridge from
cylinder Also, level indicator pin length must
be considered when installing the pump
Horizontal mount
Vertical mount
/
in
1
8
/
-20
1
4
/
-20 bolts
4
10
Fig. 2
Fig. 3
Publicidad
