SKF 90010-00 Instrucciones De Uso Y De Mantenimiento página 15

Idiomas disponibles

Prime pump

NOTE

Air purge valve (25) is located on

casting Release air after new cartridge

is installed

1 Remove any dirt or debris from cavity (23)

(→ Fig. 11) of casting

2 Fill cavity (23) with grease before installing

grease cylinder (1)

3 Install grease cylinder (1) onto pump

housing (3) and tighten

4 Loosen purge valve (25) (→ Fig. 12) and

push in cylinder rod handle until grease

begins to flow through purge valve (25)

5 Disengage rod from follower by rotating

follower handle

NOTE

Verify rod is engaged with follower

6 Push follower rod into cylinder (1)

7 Prime AECP pump after each refill or

grease cartridge change

Fig. 11

Fig. 12