Publicidad
Idiomas disponibles
Idiomas disponibles
Wiring connections
32 ft (10 m) cable with four conductors is
supplied with pump (→ Fig. 7) Use a 10
amp inline fuse Fuse is not part of pump,
rather it is apart of machine where pump is
being installed *
Cable
Wiring diagram
Recommended fuse for motor = 10 Amps
1)
Black wire to positive terminal identified by plastic dot
2)
Low level switch Maximum current 0 5 amp
3)
Brown wire to negative terminal
*
Indicates change
Cable is made up of four individual wires
that are described as follows:
• Black wire (17) is positive to motor
• Brown wire (18) is negative to motor
• Yellow (16) and white (19) wires are used
for low-level warning signal
1)
3)
13
NOTE *
Installing a 120 Ω , 1 5W resistor in
series, to the low level switch (reed
switch) is recommended to prevent
damage from more than 0 5A in rush
current
*
Indicates change
16
17
18
19
2)
Fig. 7
Fig. 8 *
Publicidad
