EVVO CLIMA 9000 Manual De Instrucciones página 102

ENGLISH
3. Press the Mode button to change the cooling and heating mode.
In each of the modes it is set as follows:
- Cooling: set the lowest temperature.
- Heating: set the highest temperature.
4. Run for about 8 minutes in each mode and check that all functions run correctly
and answer the remote control. Check the functions as recommended:
4.1 If the air outlet temperature responds to cooling and heating mode.
4.2 If the water drains properly from the drain hose.
4.3 Whether the grille and deflectors (optional) rotate correctly.
5. Observe the test status of the air conditioner for at least 30 minutes.
6. After the successful test operation, return to normal settings and press the ON/
OFF button on the remote control to turn off the unit.
7. Inform the user to read this manual carefully before use and demonstrate to
the user how to use the air conditioner, the knowledge required for service and
maintenance, and the reminder for storage of accessories.
NOTE:
If the ambient temperature is above the range referred to in the OPERATING
INSTRUCTIONS section, and cannot operate in cooling or heating mode, raise the
front panel and refer to the emergency button operation to execute cooling and
heating mode.
4. OPERATION
Operation instructions
If an attempt is made to use the air conditioner at a temperature higher than the
specified temperature, the air conditioner's protection device may start and the air
conditioner may stop working. Therefore, try to use the air conditioner in the following
temperature conditions:
Temperature
Room temperature
External
temperature
With the power supply connected, restart the air conditioner after switching it off
or switch it to another mode during operation, and the air conditioner's protection
device will start up. The compressor will restart after 3 minutes.
102
EVVO CLIMA 9000/12000/18000/24000
Mode
Heating (º C) Cooling (º C)
0 – 30 17 – 32
- 20 – 30 - 15 – 53
Dehumidification (º C)