EVVO CLIMA 9000 Manual De Instrucciones página 107

DISPLAY function
16.
- Turn on/off the panel LED display.
- Press (
GEN function
17.
1. Turn on the indoor unit at first, and press (MUTE) for 3 seconds to activate it; press it
again to deactivate this function.
2. With this function enabled, briefly press (MUTE) to select between L3- L2-L1- OFF.
3. Select OFF and wait 2 seconds to cancel.
SELF-CLEAN function
18.
- Only optional for some heating pump inverters.
- To enable this function, first turn off the indoor unit, then press (CLEAN). You will
then hear a beep, and (
appear on the remote control display.
1. This function helps to remove accumulated dirt, bacteria, etc. from the interior
evaporator.
2. This function lasts about 30 minutes and will return to the pre-setting mode. You
can press ( ) to cancel this function during the process. You will hear 2 beeps when
it is ending or cancelled.
- It is normal if there is some noise during operation, as plastic materials expand
with heat and contract with cold.
- We suggest operating this function as the next environmental condition to avoid
certain safety protection features.
Internal unit
External unit
It is recommended to use this function every 3 months.
8 °C heating function
19.
1. Press (ECO) for 3 seconds to enable this function:
remote control display.
2. This function will automatically start heating mode when the room temperature
is below 8°C (46°F) and will return to standby mode if the temperature reaches 9°C
(48°F).
3. If the room temperature is above 18°C (64°F), the appliance will automatically cancel
this function.
20. ANTI-MILDEW function
Press (ANTI MILDEW) to enable the anti-mildew function:
) to turn the panel LED display off.
) will appear on the indoor LED display, while (
Temperature < 30 ºC (85ºF)
5ºC (41ºF) < Temperature < 30ºC (86ºF)
EVVO CLIMA 9000/12000/18000/24000
ENGLISH
) will
will appear on the
will appear on the
107