Publicidad
Idiomas disponibles
Idiomas disponibles
-
To set the automatic power-on time, as follows:
1.
Press TIMER the first time to set the switch-on: (TIMER) and (
and flash on the display.
2.
Press (
) or (
the button, the time will increase or decrease by half an hour between 0 and 10
hours and by one hour between 10 and 24 hours.
3.
Press TIMER a second time to confirm.
4.
After setting the timer, select the desired mode (Cool/Heat/Auto/Fan/Dry), press
MODE and set the required fan speed by pressing FAN and press (
set the required operating temperature.
To cancel this function, press TIMER.
TIMER function, timer off
9.
-
To switch the device off automatically.
-
When the unit is switched on, you can deactivate the timer.
-
To set the automatic power-off time, as follows:
1.
Confirm that the device is switched on.
2.
Press TIMER for the first time to set the shutdown. Press (
timer as required.
3.
Press TIMER a second time to confirm.
To cancel this function, press TIMER.
NOTE: All programming must work within 5 seconds, otherwise the configuration will
be cancelled.
10. SWING function
1. Press the SWING button to activate the louvres.
2. Press ( ) to activate the horizontal flaps to swing up and down:
the remote display.
3. Do it again to stop the oscillation at the current angle.
4. If the vertical deflectors are manually positioned under the flaps, you can move the
airflow directly to the right or left.
5. Hold down ( ) for 3 seconds to select between all available airflow-angle options.
-
Never attach the "Flaps" manually! The mechanism is delicate and could be
seriously damaged.
) to set the timer for switch-on as desired. Each time you press
EVVO CLIMA 9000/12000/18000/24000
ENGLISH
) will appear
) or (
) to
) or (
) to set the
will appear on
105
Publicidad
