Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
display. Repeat the process to disable this function. After running COOL/DRY mode
for more than 30 minutes, you can activate this function for the unit to blow air for
15 minutes to dry all internal parts, thus preventing mildew. Disable the function
afterwards.
NOTE: The anti-mould function is only available in DRY (DEHUMIDIFICATION)/COOL
(COOL) mode.
Remote control
Replacing the batteries Fig. 22
-
Remove the battery-compartment cover from the back of the remote control by
sliding it in the direction of the arrow shown in the figure. Install the batteries
according to the polarity (+/-) shown on the remote control. Reinstall the battery
cover by sliding it back into place.
-
Use 2 x LRO3 AAA (1.5 V) batteries.
-
Do not use rechargeable batteries.
-
Replace old batteries with new ones of the same type when the display is no
longer readable.
-
Do not dispose of batteries as unsorted municipal waste.
-
This waste must be collected separately for special treatment.
For some models, each time you insert the batteries into the remote control for the
first time, you can set the control type to cooling only or heating pump. As soon as the
batteries are inserted, switch off the remote control and operate as follows.
1.
Hold down (MODE) until the (
type.
2.
Hold down (MODE) until the (
For some remote control models, you can program the temperature display between
ºC and ºF.
1.
Hold down (TURBO) for 5 seconds to enter Switch mode.
2.
Hold down (TURBO) until it changes to ºC and ºF.
3.
Then release the key and wait 5 seconds, the function will be selected.
NOTE:
1.
Point the remote control towards the air conditioner.
2.
Check that there are no objects between the remote controller and the signal
receiver on the indoor unit.
3.
Never leave the remote control in direct sunlight.
4.
Keep the remote control at least 1 metre away from the TV set or other electrical
appliances.
108
EVVO CLIMA 9000/12000/18000/24000
) icon flashes to set the cooling-only control
) icon flashes to set the heating-pump type.
Publicidad
